BB-ZP9D115RMLR-A Radio Modem
45
The TT command can be used to simulate full-duplex behavior.
TX (Transmit Only) Command
<RF Interfacing> The TX command
is used to set/read the
transmit/receive behaviors of the RF
module. Setting a module to TX-only
(TX = 1) may reduce latency
because the transmitting module will
never be confined to receiving data
from other modules.
VL (Firmware Version - Verbose)
<Diagnostics> The VL command is
used to read the verbose firmware
version of the RF module.
VR (Firmware Version - Short)
Command
<Diagnostics> The VR command is
used to read the firmware version of
the RF module.
Note: Firmware versions contain four significant digits - “A.B.C.D”. If B=2, the module is
programmed for operation in Australia only.
WA (Active Warning Numbers)
Command
<Diagnostics> The WA command
reports the warning numbers of all
active warnings – one warning number per line. No further information is shown and
warning counts are not reset.
Sample Output (indicates warnings 1 and 3 are currently active): 1
3
OK
AT
Command:
ATTX
Binary Command: 0x3F (63 decimal)
Parameter Range:
0 - 1
Parameter
Configuration
0
TX & RX
1
TX-only
Default Parameter Value:
0
Number of Bytes Returned: 1
AT Command: ATVL
Parameter Range: returns string
Default Parameter Value: 0
Number of Bytes Returned: 2
AT Command: ATVR
Binary Command: 0x14 (20 decimal)
Parameter Range (read-only): 0 - 0xFFFF
Number of Bytes Returned: 2
AT Command: ATWA
Parameter Range: Returns string - one
warning number per line.
