VPS-3100 User Manual
52
Figure 5.4 Executing image acquisition
3.
The camera will acquire the images after receiving an image acquisition com-
mand. The images will then be transmitted to the host PC.
4.
The camera will return to standby mode and await the next acquisition com-
mand.
5.3.2
Hardware Trigger Mode
When in hardware trigger mode, the camera’s digital input pin must be connected to
an external trigger source (e.g., a proximity sensor). The camera will begin the image
acquisition process and capture the first frame as soon as the digital input is active.
The operating procedure is given as follows:
1.
Set the camera to hardware trigger mode.
// Get the node of the trigger mode and set it on.
// The node name and setting value is dependent on camera.
IEnumNode *pTriggerMode = pCamConfigure->GetEnumNode("TriggerMode");
if (!pTriggerMode) { printf("ERROR: Invalid TriggerMode node!!");
return 0; }
pTriggerMode->SetValue(1);
Summary of Contents for VPS-3100
