Advantech UNO-3300G Series, User Manual

Page: 25 / 56

15 UNO-3300G Series User Manual
Chapter 2
H
ardware
F
unctionality
The system can provide total 20W power for slot1+slot2, it depend on PCI/PCIE card
thermal solution. If PCI/PCIE card hasn’t any FAN on the module, using Max 3W PCI/
PCIE card is recommendation; If PCI/PCIE card has FAN on the module, using Max
6W PCI/ 10W PCIE card is recommendation; If PCI/PCIE card has FAN on the mod-
ule and PCI/PCIE card can work under over 80
o
C environment, system can provide
total 20W power for slot1+slot2.
2.12 SATA HDD Drive
The UNO-3300G series product supports two 2.5" SATA HDD with up to 6Gbps
speed.
The UNO-3300G support RAID0 and RAID1. The RAID function should be enabled
in BIOS setup before you install an operating system into a RAID volume. User can
enable RAID function in BIOS sub-menu “Advance\SATA Configuration”.
Please follow the below steps to create a RAID volume.
1. Mount two SATA HDDs in the system.
2. Power on the system.
3. Press “F2” to enter into BIOS setup during POST.
4. Enable RAID mode in BIOS setup menu “Advance\SATA Configuration”.
Figure 2.13 SATA Mode Selection
5. Press “F4” to save and exist the BIOS setup.
6. Press “Ctrl+I” to enter RAID configuration utility when the Intel Rapid Storage
Technology option ROM screen appears.