SSBP-3000C
Page 31
6. Ensure that the L-Band input signal is being applied to the L-Band In port of the unit.
7. Allow the SSPB to warm up for 30 minutes, ensuring that all electrical specifications are met
(see
TABLE 2
at page 17).
7.4 FRONT PANEL OPERATION
Set-up the SSPB as follows:
1. Switch ON the main power source. The ‘
System Settings
’ menu should appear on the front
panel.
2. Allow the SSPB to warm up for 30 minutes, ensuring that all of the electrical specifications
are met see
TABLE 2
at page 17.
3. Press the [
CLEAR]
key to return to the ‘
System Settings
’ menu.
4. Use the
[
é
]
and
[
ê
]
keys to select the ‘
Set Parameters
’ menu.
5. Adjust the output frequency of the SSPB by following the sequence given in
Figure 6
at page
33.
NOTE:
In the gain or frequency value editor submenus, use the [
ç
] and [
è
] keys to select
the digit to be changed and the [
é
] and [
ê
] keys to change the value. Press the
[
Enter
] key to confirm the new value or the [
CLEAR]
key to return without the
changes.
6. Adjust the attenuation at the mixer input of the L-Band to C-Band up-converter module to
obtain a power level of – 20 dBm at the mixer input for the best signal to spurious ratio.
NOTE:
Input level + Attenuation = -20 dBm.
7. Adjust the gain of the L-Band to C-Band up-converter module to obtain the desired output
power level of the SSPB by following the sequence given in
Figure 6
at page 33.
8. If it is desired to switch the SSPB ‘ON’ or ‘OFF’, use the
[
é
]
and
[
ê
]
keys to select the
‘System Control’
menu and then press the [
Enter
] key to select the ‘ON’ or ‘OFF’
CAUTION:
The unit will always start in MUTE state (no RF output). In order to set it
functional, use the serial communications commands; the communication link through RS-232
serial interface should be established, using Term95 or HyperTerminal communications
program. Use
t2
<ENTER> command to switch for PC communications and then use
txu
<ENTER> command to un-mute the transmit path.
Summary of Contents for SSPB-3000C
