Advantech SSPB-3000C, Installation And Operation Manual, Page: 7 / 55

SSBP-3000C
Page 6
1. SAFETY
To prevent the risk of injury to personnel or loss related to equipment malfunction, ADVANTECH
uses the following symbols throughout this document to indicate safety-related information.
For your own safety, read the following carefully
BEFORE operating this equipment!
----------------------------------------------------
WARNING --------------------------------------------
--
When supplying power to this equipment, verify that the power cable (not supplied) has the correct
pin assignment as given by
TABLE 10 at page 28. Connect the cable to a properly grounded 3-pin
power outlet. Also connect a ground strap between the station’s ground bus and the ground screw
on the vertical rack. If power is supplied without grounding the equipment, there is a risk of
receiving a severe or fatal electric shock. In the context of this document any voltage that is lethal
is viewed as ‘High Voltage’. The prime power potential of 180-264 VAC applied to the
equipment is known to cause injury or death.
---------------------------------------------------
WARNING ---------------------------------------------
--
The operator cannot repair this equipment . DO NOT attempt to remove the transmitter
cover or disassemble the internal components . Only qualified service technicians should
service the transmitter. There are high-voltage parts within the unit, which present a risk of severe
injury to the untrained personnel. In addition, there is a risk of damaging the delicate components.
---------------------------------------------------
WARNING ---------------------------------------------
--
ALWAYS TERMINATE THE RF OUTPUT WAVEGUIDE PORT OF THE
TRANSMITTER WITH A RF LOAD CAPABLE OF DISSIPATING FULL CW RF
POWER. ALSO, TERMINATE THE IF INPUT CONNECTOR TO AVOID THE
POSSIBILITY OF THE UNIT BEING DRIVEN BY STRAY LEAKAGE SIGNALS
.
WARNING:
This indicates a hazardous procedure that may result in serious injury or death
if not performed properly.
CAUTION:
This indicates a hazardous procedure that may result in light-to-severe
injury or loss related to equipment malfunction, if proper precautions are not taken.