Advantech POD-6704 Series, Manual

Page: 25 / 120

Chapter 2 Installation 19
It is designed for Ethernet connectivity. Its four Ethernet ports
enable designers to create a broad range of applications including
network security systems, firewalls, intrusion detection systems,
etc.
The medium type can be configured via the RSET8139.EXE
program included on the utility disk. (See Chapter 5 for detailed
information.)
LAN LED connector (CN2,CN3,CN4,CN5)
The onboard LED will light up to show the status of the Ethernet.
RJ-45 connector (CN6,CN7,CN8,CN9)
Onboard RJ-45 standard jack.
LAN1 box (CN12)
This connector provides power supply. For detailed information
see Appendix C.
Network boot
The network boot feature is built into the BIOS. It can be enabled
or disabled in the chipset setup of the CMOS configuration. Refer
to "BIOS Setting" in Chapter 3 for more information.
2.5.3 USB Connector (CN11)
The POD-6704 board provides two USB (Universal Serial Bus)
interfaces, which give complete plug and play and also hot
attach/detach for up to 127 external devices. The USB interfaces
comply with USB specification rev. 1.0 and are fuse protected.
The USB interfaces are accessed through a 10-pin flat-cable
connector, CN11. The adapter cable has a 10-pin connector on
one end and a USB connector on the bracket.
The USB interfaces can be disabled in the system BIOS setup.