Advantech PCM-4386, User Manual, Page: 44 / 110

PCM-4386 User Manual 32
4.5.5 AC97 Audio
Select Disable if you do not want to use AC-97 audio. Option is Auto,
Disable.
4.5.6 Init Display First
This item allows you to choose which one to activate first, PCI Slot or on-
chip VGA. The choices: PCI Slot, Onboard.
4.5.7 IDE HDD Block Mode
You can enable the Primary IDE channel and/or the Secondary IDE chan-
nel. Any channel not enabled is disabled. This field is for systems with
only SCSI drives.
4.5.8 Onboard Serial Port
For settings reference the Appendix for the serial resource allocation,
and Disabled for the on-board serial connector
4.5.9 Onboard Parallel Port
This field sets the address of the on-board parallel port connector. You
can select either 3BCH/IRQ7, 378H/IRQ7, 278H/IRQ5 or Disabled. If
you install an I/O card with a parallel port, make sure there is no conflict
in the address assignments. The CPU card can support up to three parallel
ports, as long as there are no conflicts for each port.
4.5.10 Parallel Port Mode
This field allows you to set the operation mode of the parallel port. The
setting “Normal” allows normal speed operation, but in one direction
only. “EPP” allows bidirectional parallel port operation at maximum
speed. “ECP” allows the parallel port to operate in bi-directional mode
and at a speed faster than the maximum data transfer rate. “ECP + EPP”
allows normal speed operation in a two-way mode.
4.5.11 EPP Mode Select
This field allows you to select EPP port type 1.7 or 1.9. The choices:
EPP1.7, 1.9.
4.5.12 ECP Mode Use DMA
This selection is available only if you select “ECP” or “ECP + EPP” in
the Parallel Port Mode field. In ECP Mode Use DMA, you can select
DMA channel 1, DMA channel 3, or Disable. Leave this field on the
default setting.