15
Chapter 2
2.15 Floppy (CN19)
You can attach one 3.5" floppy drive to the PCM-4141's onboard control-
ler. This is useful for notebooks, for example.
A daisy-chain drive cable converter (part no. 9681000044E) is required
for a single floppy system. A 34-pin flat-cable connector is fitted on one
end of the cable converter, while the other end has one floppy disk drive
connector. It consists of a 34-pin flat-cable connector (for the 3¾î drives).
2.15.1 Connecting the floppy drive
1.
Plug the 34-pin flat-cable connector into the cable converter. Make
sure that the red wire corresponds to pin 1 on the connector.
2.
Attach the appropriate connector at the other end of the cable to the
floppy drive(s). You can use only one connector in the set. The set at the
other end (after the twist in the cable) connects to the A: drive.
When connecting a 3¾” floppy drive, you may have some difficulties in
determining which pin is number one. Look for a number on the circuit
board indicating pin number one. In addition, you should check if the
connector on the floppy drive has an extra slot. If the slot is up, pin num-
ber one should be on the right. Please refer to any documentation that
came with the drive for more information.
If your cable needs to be custom made, you can find the pin assignments
for the board's connector in Appendix C.
2.16 IR connector (CN4)
PCM-4141 provides a 5-pin IR connector.
2.17 Power and HDD LED connector (CN5)
PCM-4141 provides a 4-pin LED connector.
Summary of Contents for PCM-4141 Series
