PCM-3664 Startup Manual
3
Note:
1. You can select an IRQ from the
options shown in table 1.1, but be certain that
your selection does not conflict with other I/O
devices.
2. When Boot ROM is installed, the
RSET8019.EXE program does not support
PNP mode configuration.
To execute the configuration, to view the current
configuration, or to run diagnostics, do the following:
1. Power the PCM-3664 on. Ensure that the
RSET8019.EXE file is located in the working directory.
2. At the prompt, type RSET8019.EXE and press
<ENTER>. The ethernet configuration program will then be
displayed.
3. A simple screen displays the available options for the
ethernet interface. Highlight the option you wish to change
using the up and down keys. To change a selected item,
press <ENTER>, and a window will appear with the
available options. Highlight your selection and press
<ENTER>. Each highlighted option has a helpful message
guide displayed at the bottom of the screen for additional
information.
4. After you have made your selections and you are sure
that this is the confiruration you want, press <ESC>. A
prompt will appear asking if you want to save the
configuration. Press Y if you want to save.
The Ethernet Setup Menu also offers three very useful
diagnostic functions, which include:
1. Run EEPROM test.
2. Run diagnostics on board.
3. Run diagnostics on Network.
Each option has its own display screen which shows the
format and result of any diagnostic tests undertaken.
Remote boot ROM
A boot ROM allows you to boot the workstation directly
from the server, avoiding the need for local hard or floppy
disks. Install the boot ROM as shown below. Make sure that
you align the notch on the ROM chip with the notch on the
socket.
Hardware Installation
The following instructions tell how to install the PCM-3664
module on a CPU card. The process is similar with PC/104
CPU modules. Make sure you have properly configured the
module's jumpers and attached a boot ROM if necessary.
Warning! Turn Off your PC power supply
whenever you install or remove the PCM-3664
or connect or disconnect cables.
1. Turn the PC's power off. Turn the power off to any
peripheral devices such as printers and monitors.
2. Disconnect the power cord and any other cables from the
back of the computer.
3. Remove the system unit cover (see users' guide for your
chassis if necessary).
4. Remove the CPU card from the chassis (if necessary) to
gain access to the card's PC/104 connector.
5. Screw the brass spacer (included with the module) into
the threaded hole on the CPU card. Do not tighten too
much, or threads could be damaged.
6. Carefully align the connector pins of the PCM-3664 with
the PC/104 connecotr. Slide the module into the connector.
The module pins may not slide all the way into the
connector; do not push to hard or the module could be
damaged. If the CPU card has only an 8-bit bus, make sure
the pins on the 16-bit bus connector do not touch anything.
7. Secure the module to the CPU card to the threaded hole
in the CPU card using the included screw.
8. Reinstall the CPU card and replace the system unit
cover. Reconnect the cables you removed in step 2. Turn
the power on.
This completes the hardware installation. Install the
software drivers according to the instructions for your
operating system.
PCM-3346
Female
PC/104
Mounting Support
Male
PC/104 module
Be sure to align marks correctly
