Advantech PCM-3350 Series, User Manual

Page: 56 / 94

4 6 PCM-3350 User's Manual
6.1 Introduction
The PCM-3350 Series has an on-board LCD/VGA interface. The
specifications and features are described as follows:
6.1.1 Chipset
The PCM-3350 uses an NS CS5530A chipset for its VGA controller. It
supports many popular 18-bit LCD displays and conventional analog
CRT monitors. The VGA BIOS supports LCD. In addition, it also
supports interlaced and non-interlaced analog monitors (color and
monochrome VGA) in high-resolution modes while maintaining
complete IBM VGA compatibility. Digital monitors (i.e. MDA, CGA,
and EGA) are NOT supported. Multiple frequency (multisync) moni-
tors are handled as if they were analog monitors.
6.1.2 Display memory
With 1 ~ 4 MB share memory, the VGA controller can drive CRT
displays or color panel displays with resolutions up to 1024 x 768 at 64
K colors. The display memory can be expanded to 4 MB in BIOS for
true-color resolution of 1024 x 768.
6.2 Installation of SVGA driver
Complete the following steps to install the SVGA driver. Follow the
procedures in the flow chart that apply to the operating system that
you are using within your PCM-3350.
Important: The following windows illustrations are examples only.
You must follow the flow chart instructions and pay
attention to the instructions which then appear on
your screen.
Note 1: The CD-ROM drive is designated as "D:" throughout
this chapter.
Note 2: <Enter> means pressing the “Enter” key on the
keyboard.
Note 3: When you are using a CRT display, please make
sure that your flat panel resolution settings (in the
BIOS setup) are the same as your VGA resolution
settings (in Windows). Otherwise your display may
behave strangely.