Advantech MIT-W102 Series, User Manual

Page: 23 / 73

23
2.1 Connecting the Power
Before you can use your MIT-W102, you must fully charge the battery. Connect the
power adapter as shown and leave to charge for:
• A minimum of 2 hours when using the internal battery
Condition: the operation time is based on the LCD backlight at 50% and the average
utilization of the system under 10%.
Installation Procedures:
1. Connect the female end of the power adapter to the DC-in of MIT-W102.
2. Connect the female end of the power cord to the DC power adapter.
3. Connect the 3-pin male plug of the power cord to an electrical outlet.
NOTE: Be sure always handle the power cords by holding the plug ends only.
2.2 Connecting to a Monitor
You can connect the MIT-W102 to an external monitor for enhanced viewing.
Connect one end of a HDMI to VGA cable to the Micro HDMI port on the left side of
the MIT-W102.Connect the other end to the VGA cable and connect to the monitor.
To DC In of the equipment