Advantech L-Band Satellite Modulator, Installation And Operation Manual

Page: 16 / 90

Installation
2.1
Introduction
This chapter describes the unpacking, inspection and installation considerations.
2.1.1
Read This First!
The SBM75e Modulator must be handled carefully and thoughtfully to prevent safety hazards
and damage. Ensure the personnel designated to install the unit have the appropriate skills and
knowledge. If in any doubt, contact Advantech AMT Customer Support.
Follow the instructions for installation and only use installation accessories recommended by the
manufacturers.
2.1.2
General
Advantech AMT personnel normally perform installation of the SBM75e Modulator. This chapter
provides configuration and connection information for planning installations, checking the final
set-up in the event of a fault, modifying the requirements or moving the equipment to another
location. In the event of problems, contact Customer Support.
2.1.3
Site Requirements
2.1.3.1 Power Supplies
See Appendix A, Technical Specification for a full specification.
2.1.3.2 Environment
See Appendix A, Technical Specification for a full specification.
Do not install this product in areas of high humidity or where there is danger of water ingress.
The installation site should be compatible with the location used for other electronic equipment.
That is, the building should be free from excessive dust and moisture. The room should not
exceed the recommended temperature range (defined in Appendix B Technical Specifications).
The installation location should allow for ample airflow. Also, allow extra room for service access
to cables and wiring.
2.1.4
EMC Compliance Statements
1
2.1.4.1 EN 55022
This equipment is a Class A product. In a domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures.
2.1.4.2 FCC
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own
expense.
1
The EMC information was correct at the time of manufacture. The EMC tests were performed with the Technical earth attached.
2-2
SBD75e Series Modulator Installation and Operation Manual