![background image](http://html.mh-extra.com/html/advantech/icam-500-series/icam-500-series_programming-manual_3047974062.webp)
ICAM-500 Programming Guide
56
4.9
module device
4.9.1
class Network
4.9.2
class Firmware
class
device.Network
info
()
Get ICAM-500 device network configuration
Returns:
tuple(str, str, str, str, str)
Input value out of range.
1. mode : ‘dhcp’ or ‘static’
2. IP: IPv4 address
3. netmask: IPv4 netmask
4. gateway: IPv4 gateway address
5. MAC adress: ICAM-500 MAC address
config
(
mode='dhcp', ip=None, netmask=None, gateway=None
)
Configure ICAM-500 network
info
()
Get ICAM-500 device network configuration
Parameters: mode: str
‘dhcp’: Set network in DHCP mode. ip, netmask, gate
-
way must set None.
‘static’: Set a static IPv4 address.
ip: str
IPv4 address. ex. ‘192.168.0.100’
netmask: str
IPv4 netmask. ex. ‘255.255.255.0’
gateway: str
IPv4 gateway. ex. ‘192.168.0.1’
Raises:
AttribureError
If mode is “dhcp”, ip/netmask/gateway must set None.
class
device.Firmware
(
camera
)
info
()
Read firmware version
Returns:
str
Firmware version in date format(YYYYMMDD). ex. ‘20220216’
Summary of Contents for ICAM-500 Series
