System Event Log – Syslog Configuration
Configure the system event mode to collect system log.
•
Syslog Client Mode:
Select the system log mode—
Client Only
,
Server Only
, or
Both
.
•
System Log Server IP Address:
Assign the system log server IP.
•
When Syslog Client Mode is set as
Client Only
, the system event log will only be reserved in the
switch’s RAM until next reboot. When Syslog Client Mode is set as
Server Only
, the system log will
only be sent to the syslog server and you have to type the IP address in the Sysylog Server IP Address
column. If the Syslog Client Mode is set as
Both
, the system log will be reserved in the switch’s RAM
and sent to server.
•
Click
Reload
to refresh the events log.
•
Click
Clear
to clear all current events log.
•
After configuring, click
Apply
.
Figure 3.3-12
Syslog Configuration
EKI-7556MI_Manual
56
Summary of Contents for EKI-7556MI
