Advantech EKI-6331AN-BE, User Manual

Page: 54 / 72

EKI-6331AN-BE/EKI-6332GN-AE User Manual
44
5.8 SNMP Management
The IEEE 802.11n VAC Access Point supports SNMP for convenient remote man-
agement. Open “SNMP Settings” in “Management” shown below. Set the SNMP
parameters and obtain MIB file before remote management.
Figure 5.8 SNMP Management

Protocol Version:
Select the SNMP version, and keep it identical on the IEEE 802.11n VAC
Access Point and the SNMP manager. The IEEE 802.11n VAC Access Point
supports SNMP v2/v3.

Server Port:
Change the server port for a service if needed; however you have to use the
same port to use that service for remote management.

Get Community:
Specify the password for the incoming Get and GetNext requests from the man-
agement station. By default, it is set to public and allows all requests.

Set Community:
Specify the password for the incoming Set requests from the management sta-
tion. By default, it is set to private.

Trap Destination:
Specify the IP address of the station to send the SNMP traps to.

Trap Community:
Specify the password sent with each trap to the manager. By default, it is set to
public and allows all requests.

Configure SNMPv3 User Profile
For SNMP protocol version 3, you can click “Configure SNMPv3 User Profile” in
blue to set the details of SNMPv3 user. Check “Enable SNMPv3 Admin/User” in
advance and make further configuration.
– User Name: Specify a user name for the SNMPv3 administrator or user. Only
the SNMP commands carrying this user name are allowed to access the
IEEE 802.11n VAC Access Point.
– Password: Specify a password for the SNMPv3 administrator or user. Only
the SNMP commands carrying this password are allowed to access the IEEE
802.11n Wireless VAC Access Point.
– Confirm Password: Input that password again to make sure it is your
desired one.