21
AVAS-212 User Manual
5.2
NDcoder Installation
The overall installation procedure of the AVAS-212 system has been
described in the previous section. This section provides information
about the installation of the AVAS-212 NDcoders.
Section 5.2.2 describes the interfaces on right side of the AVAS-212
NDcoder. Section 5.2.4 describes the interfaces of the left side of
AVAS-212 NDcoder 10G DVI.
5.2.1
Unpacking Instructions
When unpacking the AVAS-212 NDcoder, check the condition of all components before
installation. If the equipment is damaged, do not install it but return it for inspection and repair.
Do not open the NDcoder, the power supply unit, or any other component.
5.2.2
External Interfaces on the AVAS-212 NDcoders
Figure 4 shows the external interfaces of the AVAS-212 NDcoders. The
NDcoder has the following interfaces on the front panel:
10G Network Connection
. The NDcoder provides an SFP cage
that can be used to place an SFP+ module. This interface is
used to connect the NDcoder to the AVAS-212 network.
1G Network Connection
. This interface is reserved for future use.
Power Connector
. This connection is used to power the AVAS-
212 NDcoder with the power supply unit delivered with the
NDcoder.
Power
Figure 4 - External Interfaces of the AVAS-212 NDcoder (right I/O)