![background image](http://html1.mh-extra.com/html/advantech/arma-k100-crm/arma-k100-crm_installation-and-operating-manual_2856490024.webp)
ARMA-K100-CRM
23
3. INSTALLATION
3.1 MOUNTING CONSIDERATIONS
The unit is designed for installation in a standard 19” equipment rack and fixed in place at the
front panel
3.2 INSTALLATION PROCEDURE
1. Mount the unit in the desired location, ensuring that there is a clearance of at least 1 foot
(30 cm) between the air intakes, exhaust and any surface which may obstruct air flow.
2. Connect the waveguide output of the SSPA using gasket, screws #6-32 x 1/2” and #6
lock-washers.
3. Connect the RF source to the RF input, see
Figure 1
at page 12
& Figure 2
at page 13.
4. Connect the AC power source to the AC socket at the rear of the amplifier.
5. Proceed to
Section 4
at page 24 for
OPERATION and CONFIGURATION
INSTRUCTIONS.
6. In case of use of pressurized output waveguide system, it is mandatory to install pressure
window in order to protect Amplifier from high pressure
NOTE:
The rotating speed of cooling fans is temperature dependent.