Advantech ARK-3400, User Manual, Page: 44 / 87

ARK-3400 User Manual 32
– 1600 x 1200 LVDS (LFP1)
„ Boot Display [CRT+EFP]
This item allows the user to adjust panel resolution.
3.2.5 Integrated Peripherals
Figure 3.5 Award BIOS Integrated Peripherals
„ OnChip IDE Device
This item enables users to set the OnChip IDE device status, includes enable
IDE devices and setting PIO and DMA access mode, and some of new chipset
also support for SATA device (Serial-ATA).
„ Onboard Device
This item enables users to set the USB, Azalia/AC97, LAN status enable or dis-
able.
„ Super IO Device
This item enables users to set the Super IO device status, includes enable
Floppy, COM, LPT, IR and control GPIO and Power fail status.
„
Onboard Serial port 1 [3F8]
This item allows user to adjust serial port 1 address.
„ Serial port 1 Use IRQ [IRQ3]
This item allows user to adjust serial port 1 IRQ.
„ SP 1 AutoFlow Control [Disabled]
Auto flow control is used in RS-485, is used to tri-state the transmitter when no
other data is available, so that other nodes can use the shared lines.
When auto flow control is enable, the device monitors the local output buffer for
not empty and empty conditions. If enable, the flow control will force signal to
the desired polarity under the empty or not empty condition.
„ Onboard Serial port 2 [3E8]
This item allows user to adjust serial port 2 address.
Note! This "Integrated Peripherals" option controls the configuration of the
board's chipset, includes IDE, ATA, SATA, USB, AC97, MC97 and
Super IO and Sensor devices; this page depends on the particular
chipset installed.