
ARK-3400 User Manual
10
2.2.5
COM Connector
ARK-3400 provides four D-sub 9-pin connectors that are serial communication inter-
face ports. The COM1/2 in the rear side support RS-232/422/485 by jumper setting,
the COM3/4 in the front side support RS-232 only. Default setting of these four ports
are RS-232.
Figure 2.7 COM port connector
2.2.6
eSATA Connector
ARK-3400 has a 7 pin external connector for eSATA device. That is fully compliant
with SATA I/SATA II standards, its can be access with external SATA I/SATA II device
then up to 300MB/sec.
Figure 2.8 eSATA connector
Table 2.1: COM standard serial port pin assignments
RS-232
RS-422
RS-485
Pin
Signal Name
Signal Name
Signal Name
1
DCD
Tx-
DATA-
2
RxD
Tx+
DATA+
3
TxD
Rx+
NC
4
DTR
Rx-
NC
5
GND
GND
GND
6
DSR
NC
NC
7
RTS
NC
NC
8
CTS
NC
NC
9
RI
NC
NC
Note: NC represents “No Connection”.
Summary of Contents for ARK-3400
