Advantech AMAX-4800 Series, User Manual

Page: 4 / 102

AMAX-4800 User Manual iv
Safety Instructions
1. Read these safety instructions carefully.
2. Retain this user manual for future reference.
3. Disconnect the equipment from all power outlets before cleaning. Use a damp
cloth for cleaning. Do not use liquid or spray detergents.
4. For pluggable equipment, the power outlet socket should be located near the
equipment and easily accessible.
5. Protect the equipment from humidity.
6. Place this equipment on a reliable surface during installation. Dropping or letting
the equipment fall may cause damage.
7. The openings on the enclosure are for air convection. Protect the equipment
from overheating. Do not cover the openings.
8. Make sure the voltage of the power source is correct before connecting the
equipment to the power outlet.
9. Position the power cord so that people cannot step on it. Do not place anything
over the power cord.
10. All cautions and warnings on the equipment should be noted.
11. If unused for a long time, disconnect the equipment from the power source to
avoid damage from transient overvoltage.
12. Never pour liquid into an opening. This may cause fire or electrical shock.
13. Never open the equipment. For safety reasons, the equipment should be
opened only by qualified service personnel.
14. If one of the following occurs, have the equipment checked by service person-
nel:
 The power cord or plug is damaged.
 Liquid has penetrated the equipment.
 The equipment has been exposed to moisture.
 The equipment is malfunctioning, or does not operate according to the user
manual.
 The equipment has been dropped and damaged.
 The equipment shows obvious signs of breakage.
15. Do not store the equipment in an environment where the temperature fluctuates
below -20 °C (-4 °F) or above 60 °C (140 °F) as this can cause damage. The
equipment should be stored in a controlled environment.
16. The battery is at risk of explosion if incorrectly installed or replaced. Replace
only with the same or equivalent type recommended by the manufacturer. Dis-
card used batteries according to the manufacturer’s instructions.
17. According to IEC 704-1:1982 specifications, the sound pressure level at the
operator’s position does not exceed 70 dB (A).
DISCLAIMER: These instructions are provided in accordance with IEC 704-1. Advan-
tech disclaims all responsibility for the accuracy of any statements contained herein.