Base replacement procedure:
1. Note: Can be done on scissors lift in the ceiling.
2. Remove system air pressure.
3. Remove control valve and hose stop.
4. Allow hose to retract completely.
5. Remove air line from swivel.
6. Remove 7/8” axle nut.
7. Pull hub off base.
8. Assemble stop dog assembly on new base.
9. Remove old base.
10. Using new base, reverse disassembly procedure to reassemble.
Rewind Spring Assembly Removal and Replacement.
1. Disconnect air and oil.
2. Remove gun and hose stop.
3. Allow hose to fully retract into reel. NOTE: Typically, the retraction is about four rotations past the
hose stop. The retraction unloads/releases the spring motor tension.
4. Remove swivel.
5. Remove axle snap ring and axle washer.
6. Remove reel hub (with delivery hose, rewind spring assembly, etc.) from the reel base. NOTE: Axle
stays on base.
7. Remove four nuts that protrude from the far side (side opposite the rewind spring canister) of the
hub. The four nuts screw onto studs protruding from the interior side of the rewind spring canister.
The four nuts attach the rewind spring canister to the reel hub.
WARNING: Exposure of the encapsulated/enclosed rewind spring could result in severe bodily injury. The
canister must remain sealed/complete/intact. Do not remove the nuts on the exterior face of the rewind
spring canister.
8. Remove the complete/intact rewind spring canister and replace the rewind spring canister.
9. Reassemble the reel and adjust rewind spring tension as appropriate.
8
Advantage TIM-3600 Series Reel, Manual, June2020
