www.advancedco.com
8
1.8 Changing the interface settings
The above defaults can be changed as
required after moving switch SW1 over to the
“Setup” position (i.e. move to left).
NORMAL
SETUP
SW1
Use any of the following:-
Connect a PC to the RS232 connector and run the “Virtual Terminal” display and select “Setup” from the virtual
display.
Connect a PC to the RS232 connector and, using the MX Configuration software, transfer a file from the PC to
the interface.
“Zone Text” should also be entered for the interface so that any events created by the ipGateway can be readily
identified from displays throughout the fire system network.
1.9 Normal Operation
If a display has been used to configure the interface, check that all commissioning operations are complete, with
the display showing “[Commission]” in the top left corner of the display.
Ensure the RS232 conn
ections to the ipGateway are made, then move switch SW1 out of “Setup” (i.e. move the
switch to the right).
2 The Server
2.1 Configuring the server
The ipGateway requires several pieces of configuration information to allow it to exist on a network. The
MxConfig
Tool provides the necessary fields in the “Panel Details” view, under the heading “TCP/IP Settings”.
