Mod5 Series 0.50mm Pitch
Flip-Top
™
BGA Socket
5 Energy Way, West Warwick, Rhode Island 02893 USA
Tel: 800.424.9850 | 401.823.5200 | Fax: 401.823.8723
E-mail: [email protected] | Web: www.advanced.com
www.advanced.com
Specifications subject to change without notice. Dimensions shown: inch/(mm) Flip-Top is a trademark of Advanced Interconnections Corp. Item FT-INS-003 (Rev 5/10)
Usage
Installation
BGA Device Removal
1. Loosen turn-screw heat sink until
support plate moves freely.
To avoid
damage to the socket, do not attempt to
open the lid until the turn-screw heat
sink has been loosened.
2. Press latch mechanism. Refer to figure
4a in Step 4.
3. After lid is opened, remove the support
plate and set aside.
4. Remove BGA device. Use of vacuum
suction pen/tool is recommended.
Additional Info
After Installation
1. Place BGA device into opened Flip-Top
BGA Socket, aligning the A1 position on
the BGA with the chamfered corner of the
Flip-Top BGA Socket. Use of vacuum
suction pen/tool is recommended.
2. Insert support plate with the extended
square ram side toward the BGA device.
3. Close lid, making sure the latch is firmly
engaged.
4. Tighten turn-screw heat sink in a clock-
wise direction until it just makes contact
with the support plate. This may be done
by hand or with a 1/8” hex drive (sup-
plied).
5. Past this initial contact point, turn the
turn-screw heat sink 90º-110º (approx 1.0
lb-in); for the largest position counts, turn
to 110º-135º (approx 3 lb-in
MAX).
Over
tightening of turn-screw heat sink may
result in damage.
6. Socket is now ready for operation.
INSTALLATION & GENERAL USAGE
INSTRUCTIONS
Fig.4a
Fig.5
Fig.4
Fig.4b
Fig.3
STEP 3
Install supplied #0-80 screws in rear
of socket as shown in Fig. 3 and
tighten using the supplied hex
wrench (recommended torque value
is 1.20 lb-in).
STEP 4
Open lid by pressing upper portion
of latch mechanism back toward
socket (see Fig. 4 and 4a).
Lid will open approximately 115º,
allowing access to the front two
screw locations and allowing for
device insertion (see Fig. 4b).
STEP 5
Install supplied #0-80 screws, as
shown in Fig. 5, and tighten using
the supplied hex wrench
recommended torque value is
1.20 lb-in).
