Figure 42: Boreas Web UI Odometer Configuration Page
9.1.3.7 Reset
The Reset button causes the system to perform a power cycle. No configuration settings or state data are lost.
The Cold Start button clears all filters, and connections are reset and must re-established. No configuration
settings are lost.
The Factory Reset button resets all Boreas settings back to their factory defaults, including state data and all
configuration settings. It also erases the hot start data so that the system is forced to perform a cold start.
Note
: A Factory Reset will re-enable the DHCP Client and lose any static IP address settings.
Figure 43: Boreas Web UI Reset Page
9.1.3.8 Reference Point Offsets
The Reference Point Offsets page allows the user to set measurement points away from its default position at
the physical centre of the Boreas unit. The primary reference point offset applies to data from all ANPP packets
as well as all peripheral output such as NMEA messages and Heave Point 1.
The Centre of Gravity (COG) Lever Arm Offset should be used to define where the centre of gravity is for the
vehicle. It is useful in applications, such as a surface vessels, to improve the ability of the
to complete coarse alignment.
The Heave Points 3 and 4 allow the user to offset reference points for the heave values 3 and 4 in the
.
v1.2
Page 63
11 Oct 2022
Boreas Reference Manual • Configuring and Monitoring Boreas
