Advanced Instruments 3300, User Manual

Page: 35 / 77

Data Capture
To change the RS-232 output between standard mode and capture mode,
take the following steps:
NOTE With Capture selected, freezing curve output data will be
presented to the serial port in real time. This data is updated
every 50 msec after crossing 0ºC, and may be captured with
any RS-232 compatible computer program for use in plot-
ting freezing curves.
In Standard mode, ony the final result and some status mes-
sages will be presented to the serial port.
1. At “ Osmometer Ready ” , the two multifunction soft keys are labeled
[CALIB] and [DIAG] , respectively. Press the soft key labeled
[DIAG] to enter the diagnostic test menu.
2. While you are within the diagnostic test menu, the soft key labels
will change to [START] and [INDEX] . Use the [INDEX] soft key
to cycle through your choices until you see “ 12. Data Capture ”.
3. Press [START] to enter the selection menu.
4. Select the soft key for the mode you want to use.
5. Press the two soft keys simultaneously to lock in your selection.
6. Press the two soft keys again simultaneously to return to
“ Osmometer Ready ”.
Language
To reset the display language, take the following steps:
1. At “ Osmometer Ready ” , the two multifunction soft keys are
labeled [CALIB] and [DIAG] , respectively. Press the soft key
labeled [DIAG] to enter the diagnostic test menu.
2. While you are within the diagnostic test menu, the soft key labels
will change to [ START] and [INDEX] . Use the [INDEX] keypad to
cycle through your choices until you see “ 14. Select Language ” .
17
Instrument Operation