Advance acoustic Terra 5200 B, Service Manual

Page: 85 / 112

DRIVE SYSTEM
SERVICE MANUAL ENGLISH
Terra™ 5200 1463546000(1)2008-07 83
FORWARD/REVERSE GEAR PEDAL CONTROL BOARD REPLACEMENT
Drive the machine on a level floor. 1.
Engage the parking brake with the pedal and the lever (25 and 18). 2.
Turn the ignition switch (17) to “0”. 3.
Remove the forward/reverse gear pedal mounting screws (A). 4.
Remove the cover (B). 5.
Disconnect the electrical connector (C) by disengaging the fastener on the lower side. 6.
Remove the forward/reverse gear pedal (D). 7.
Loosen the dowel (E) at the workbench. 8.
Remove the connecting rod (F) from the pin (G). 9.
Remove the screws (H). 10.
Remove the board assembly (I). 11.
Remove the shims (J). 12.
Assemble the components in the reverse order of disassembly, and note the following: 13.
Normally the tie rod (K) does not require adjustment, however, when the electronic board (I) and the connecting rod (F) are •
reinstalled check that the tie rod (K) is properly adjusted as shown below:
Remove the terminal (M) from the connecting rod (L). –
When the connecting rod is released, check that the terminal (M) is aligned with the connecting rod hole (N) (as shown –
in the figure).
If necessary, perform the alignment by adjusting the nuts (O) and the tie rod (K); then, tighten the nuts.
Install the terminal (M) on the connecting rod (L). –
Perform some operation tests on the forward/reverse gear pedal (19) and check the following conditions with the ignition 14.
switch (17) in “I”:
When the pedal (19) is released the machine should not move. •
When the pedal (19) is slightly pressed forward or backward, the machine should start moving slowly. •
S300596