Advance acoustic LIGHTNESS 3, Manual

Page: 29 / 54

Carbon seatboard
A new footboard is pushed into its pocket in the end of the speedbag.
This pocket is closed by Velcro strips
Speed loop
The lower speed loop has a grey locating loop . This goes through
the loop in the black bungee fixed to the centre of the footboard .
Pull the whole speedloop component through the grey loop to make a
loop-in-loop connection with the pull-forward bungee.
Lead the grey speedlines (minus Brummel hooks) through the me-
tal D rings on each side of the seat surface, between speedbag and
harness to the Ronstan pulleys; aft through these, then up through the
openings in the harness sides. Loop the speedline loops through and
over the Brummel hooks in the usual way (anchor hitch).
Caution: Be sure to check the run of speed and speedbag lines.
These must not cross, or cutting may result.
Caution: Only use the original speed lines and speed loop. A
different line or a solid speedbar could seriously damage the
speedbag and harness by point-load or friction.
29