Advance acoustic LIGHTNESS 3, Manual

Page: 26 / 54

Speedbag
The LIGHTNESS 3 comes already fitted with the speedbag you orde-
red. The speedbag is principally secured to the harness at three pla-
ces: by a loop at each carabiner, zips along the sides and Velcro un-
derneath of the LIGHTNESS 3 and the lower speedbag lines to the
sides of the seat shell.
To remove a speedbag for replacement, first free the grey support lo-
ops from the carabiners. Then open both side zips , and free
the Velcro underneath . Take out the speed lines and speed loop.
Now release both lower, blue speedbag lines which connect the spee-
dbag to the harness.
For a Standard speedbag next release the lower red-marked part of
the lines from the red attachment points on the footboard
. Free the
anchor hitch (kite) knots from the red lines. Then loosen the kite knots
on the blue lines below the black setting balls
and pull the lower,
red sewn ends of the lines out of the kite knots. Then completely free
the blue lines from the black tabs on the edge of the seat surface.
For a Light speedbag directly release the kite knots on the upper ends
of the blue lines, so as to pull these off the grey adjustment lines, then
thread the grey adjustment lines off the black tabs on the edge of the
seat surface.
The LIGHTNESS 3 is now ready for its new/different speedbag.
Proceed in the following three steps:
For a Standard speedbag first release the two lower blue speedbag
lines from their attachment on the footboard. Loosen the kite knots
and pull the blue lines off the red attachment lines.
26