FORM NO. 56043098 - Convertamatic
™
24C, 24D, 26C, 26D, 28C, 28D -
23
SCRUB SYSTEM
SCRUB BRUSH MOTOR/GEARBOX REMOVAL (DISC)
1
Follow the steps in the
Scrub Brush Deck Removal (Disc)
section.
2
Turn the brush deck on its back.
3
Remove the scrub brushes from the brush holders. If removing both motor/gearboxes mark the location of the holders and motors to the brush deck for proper
re-assembly.
4 See
Figure
3.
Remove the (3)
(E)
Hex Screws from the
fl
exible coupler that attaches the brush holder to the drive Hub
(F)
of the Motor/Gearbox Assembly
you want to remove.
5
Remove the (1) Hex Screw
(G)
that secures the Hub
(F)
to the output shaft on the defective motor/gearbox. Then pull the hub from the shaft and save the
key.
6
Remove the (4)
(H)
Screws and separate the defective Motor/Gearbox Assembly
(I)
from the scrub deck.
7
Re-assemble in reverse order and test for proper operation. Note: Apply a small amount of grease or a product called “Never Seize” to the gearbox output shaft
when reinstalling the Drive Hubs
(F).
FIGURE 3
Summary of Contents for Convertamatic 24C
