INSTRUCTIONS FOR USE
ENGLISH
Micromatic™ M17B
909 5853 000(3)2008-11
17
SQUEEGEE CLEANING
NOTE
The squeegee must be clean and its blades must be in good conditions in order to get a good drying.
WARNING!
It is advisable to wear protective gloves when cleaning the squeegee because there may be sharp debris.
Drive the machine on a level
fl
oor.
1.
Make sure that the switches (65 and 66) are turned to “0”.
2.
Lower the squeegee with the lever (19).
3.
Disconnect the vacuum hose (22) from the squeegee.
4.
Loosen the handwheels (12) and remove the squeegee (11).
5.
Wash and clean the squeegee; in particular, clean the compartments (A, Fig. 6) and the vacuum hole (B) from dirt and debris.
6.
Check the front blade (C) and the rear blade (D) for integrity, cuts and tears; if necessary replace them (see the procedure in
7.
the following paragraph).
Assemble in the reverse order of disassembly.
8.
SQUEEGEE BLADE CHECK AND REPLACEMENT
Clean the squeegee as shown in the previous paragraph.
1.
Check that the edges of the front blade (E, Fig. 6) and of the rear blade (I) lay down on the same level, along all their length;
2.
otherwise adjust their height as shown below:
Remove the
fi
xing springs (F) and adjust the front blade (C) and the rear blade (D).
•
Install the mounting springs on the front and rear blades.
•
Check the front blade (C) and rear blade (D) for integrity, cuts and tears; otherwise replace them according to the following
3.
procedure. Also check the front corner (H) of the rear blade for wear; if it is worn, overturn the blade to replace the worn corner
with the other one (I), if it is integral. If the other corner is worn too, replace the blade according to the following procedure:
Remove the
fi
xing springs (F) and replace (or overturn) the rear blade (D).
•
Install the mounting springs on the front and rear blades.
•
Install the squeegee (11) and screw down the handwheels (12).
4.
Connect the vacuum hose (22) to the squeegee (11).
5.
I
G
A
E H
B
A
F
F
D
C
Figure 6
S310230A
