INSTRUCTIONS FOR USE
ENGLISH
Micromatic™ M17B
909 5853 000(3)2008-11
15
RECOVERY TANK REMOVAL
To check the batteries, or to perform other procedures, it may be necessary to remove the recovery tank (31) as shown below.
Empty the recovery tank (31) as shown in the relevant paragraph.
1.
Drive the machine on a level
fl
oor.
2.
Make sure that the switches (65 and 66) are turned to “0”.
3.
Disconnect the vacuum hose (22) from the squeegee (11).
4.
Disconnect the recovery water drain hose (16) from the bracket (17).
5.
Open the cover (6).
6.
Grasp the recovery tank (A, Fig. 5) in the area (B) and slightly raise it.
7.
Disconnect the vacuum hose (C) from the tank, then remove the tank (A) with the hoses (D) and (E).
8.
A
B
C
D
E
Figure 5
S310233A
MACHINE LONG INACTIVITY
If the machine is not going to be used for more than 30 days, proceed as follows:
Perform the operations described in the After Using The Machine paragraph.
1.
Remove the recovery tank (31) according to the procedure shown in the previous paragraph, then disconnect the battery
2.
negative terminals (50).
Install the recovery tank (A).
3.
Store the machine in a clean and dry place.
4.
FIRST PERIOD OF USE
After the
fi
rst period of use (
fi
rst 8 hours) it is necessary to check the
fi
xing and connecting parts of the machine for proper
tightening. Check the visible parts for integrity and leakage.
