ENGLISH
INSTRUCTIONS FOR USE
10
909 5853 000(3)2008-11
Micromatic™ M17B
USE
WARNING!
On some points of the machine there are some adhesive plates indicating:
DANGER
–
WARNING
–
CAUTION
–
CONSULTATION
–
While reading this Manual, the operator must pay particular attention to the symbols shown on the plates.
Do not cover these plates for any reason, in case of damage replace them immediately.
BATTERY CHECK/SETTING ON A NEW MACHINE
WARNING!
The electric components of the machine can be seriously damaged if the batteries are either improperly installed
or connected. The batteries must be installed by quali
fi
ed personnel only. Check the batteries for damage before
installation. Handle the batteries with great care. Install the battery terminal caps supplied with the machine.
The machine requires two 12V batteries, connected according to the diagram (51).
The machine can be supplied in one of the following modes:
GEL batteries already installed on the machine
Start the machine by pressing the brush/pad-holder and vacuum system switches (65 and 66). If the green warning light (62)
–
turns on, the batteries are ready to be used.
If the yellow or red warning light (63 or 64) turns on, it is necessary to charge the batteries before using the machine (see
–
procedure in Maintenance chapter).
Without batteries
Buy appropriate batteries [See the Technical Data paragraph and the diagram (51)]. For the battery choice and installation,
–
apply to quali
fi
ed battery retailers.
Set the machine for GEL batteries, then install the batteries on the machine and charge them, as shown in the next paragraph.
–
GEL BATTERY SETTING, INSTALLATION AND
CHARGING
The electronic board of the machine is to be set according to
the type of batteries chosen, gel (GEL) batteries. Proceed as
follows.
Machine setting
The machine factory setting is for GEL batteries; if this
1.
setting corresponds to the type of batteries supplied, go to
step 4. Otherwise, carry out steps 2, and 3 too.
Remove the screws (A, Fig. 1), then remove the electrical
2.
component box cover (B).
WARNING!
Do not move/set the adjacent switch (D).
Reinstall the electric component box cover (B) and tighten
3.
the screws (A).
B
A
A
C
D
Figure 1
S310234B
