ADTRAN NetVanta 1638, Hardware Installation Manual

Page: 26 / 36

Unit Installation NetVanta 1600 Series Hardware Installation Guide
26 Copyright © 2011 ADTRAN, Inc. 61700568F1-34A
5. UNIT INSTALLATION
The instructions and guidelines provided in this section cover hardware installation topics, such as mounting
options, supplying power to the unit, replacing the power supply, and installing option modules. These
instructions are presented as follows:
• Mounting Options on page 27
• Supplying Power to the Unit on page 28
• Replacing the Power Supply on page 28
• Installing XAUI Interface Modules on page 29
• Installing a SODIMM for Expandable Memory on page 30
For information on configuring a specific application, refer to the configuration guides provided on the
ADTRAN’s Knowledge Base or the AOS Command Reference Guide (ADTRAN’s Knowledge Base article
2219).
Tools Required
The customer-provided tools required for the hardware installation of the NetVanta are:
• Ethernet cables
• Network cables (module dependent)
• Phillips-head screwdriver (rack-mounted applications only)
To prevent electrical shock, do not install equipment in a wet location or during a
lightning storm.
The NetVanta 1600 Series is intended to be to be installed, maintained, and serviced by
qualified service personnel only and should be installed in a restricted access location as
described in UL/IEC 60950-1.
Ethernet and PoE cables are intended for intra building use only. They should not be run
outside the building.
Do not remove the cover on the RPS or EPS connectors on the rear of the unit. These
connectors are reserved for future use.
To access the CLI of the NetVanta, you will also need a PC with terminal emulation
software and a console port cable. Instructions on how to access the CLI are available in
the quick start guide shipped with your unit or online at
ADTRAN’s Knowledge Base .