2
617111561F1-13A
Installing the NetVanta 1561i-04 Switch
Package Contents
■ NetVanta 1561i-04 switch
■ DC-power and DI/DO terminal blocks (connected to unit)
■ DB-9 to RJ-45 cable
■ Mounting kit containing:
♦ DIN rail mounting kit (bracket and three screws)
♦ Wall mounting kit (2 brackets and eight screws)
■ Quick Start guide
Installation Overview
To install the switch, you will need to do the following:
1. Mount the switch
2. Connect DC power terminal block
3. Connect DI/DO terminal block
4. Install SFP modules
Prior to Installation
Before installing the equipment, inspect the switch. If damage has occurred during shipping, file a claim with the carrier, and then contact ADTRAN Customer
Support. For more information, refer to the product warranty available online at
https://adtran/wp_support_warranty
Mounting the NetVanta 1561i-04 Switch on a DIN Rail
Follow these instructions to mount the NetVanta 1561i-04 switch to a DIN rail using the enclosed DIN rail mounting kit:
1. Attach the DIN rail mounting bracket to the back panel of the chassis as shown in
. Insert the provided screws and tighten them with a screwdriver to
secure the bracket.
Figure 2. Attach the DIN Rail Bracket to the Switch’s Rear Panel
2. Insert the upper lip of the DIN rail into the DIN rail mounting kit and press the switch towards the DIN rail until it snaps into place, as shown in
Figure 3. Attach Switch to DIN Rail
NOTE
g
Refer to the national, state and local electrical codes for the requirements for power, grounding, wiring, and installation methods.
