Physical Description
NetVanta 1000 Series Switch Hardware Installation Guide
22
© 2004 ADTRAN, Inc.
61200500L1-34C
3.
PHYSICAL DESCRIPTION
Front Panel RJ-45 Ports and LEDS
The NetVanta front panels contain twenty-four 10/100BaseT Mbps Ethernet ports (RJ-45). Theses ports
are consecutively numbered one through twenty-four, from left to right, with the numbers screened directly
above each port. Status LEDs for each of these ports are located directly over these numbers. (See
Figures 1 through 4.)
Front Panel Gigabit Ethernet Interfaces and LEDs
In addition to the Ethernet ports, the NetVanta1224ST front panel contains two Gigabit Ethernet interfaces,
and the NetVanta 1224STR contains one Gigabit Ethernet interface. These interfaces are provided as SFP
slots and RJ-45 jacks. Use either the SFP slots (see
on page 23) or the RJ-45 jacks. These
interfaces are labeled
G1
/
G2
, and their status LEDs are located to the left of RJ-45 port 1 (they are labeled
as
G1
and
G2
), above the LED labeled
STAT
.
Other Front Panel LEDs
To the lower left of RJ-45 port 1 is an LED labeled
STAT
which indicates the unit’s status. The
NetVanta 1224STR and NetVanta 1224R also contain LEDs labeled
WAN
and
DBU
. These LEDs indicate
the status of the interfaces added by an installed module (WAN-network interface module or DBU-dial
backup module). Table 1 on page 23 describes all of these LEDs, and Appendix A shows the pinouts for
the connectors.
Figure 1. NetVanta 1224 Front Panel Layout
Figure 2. NetVanta1224ST Front Panel Layout
