ADTRAN ISU 2x64, User Manual

Page: 51 / 165

Chapter 6. Configuration
61200051L1-1D ISU 2x64 Dual Port ISDN Service Unit User Manual
37
be terminated at any time by transmitting the CTRL+X (ASCII
018) after the AT attention code. The ISU 2x64 ignores this com-
mand line and issues an OK response.
The command line may contain a single command or a series of
commands after the AT attention code. When a series of com-
mands are used, the individual commands may be separated
with spaces for readability.
The maximum length for a command line is 40 characters. Each
command line is executed by the ISU 2x64 upon receipt of a ter-
minating character.
The default terminating character is a carriage return (ASCII 013),
but it can be changed by writing a different value to register S3.
Before the terminating character is transmitted, the command
line can be edited by using the backspace character (ASCII 008) to
erase errors so the proper commands can be entered. Examples
of using AT commands are as follows.
Using an AT Command
Type AT followed by the letter of the command and numeric
value of the setting desired and then press
Enter .
Example:
ATI1
Returns the software version of the unit.
Using S-Registers
The configuration of the ISU 2x64 can be changed and/or
reviewed with S-registers. See the appendix S-Register List for a
description of each S-register and its corresponding range of val-
ues.
Reading an S-Register
Type ATS followed by the number of the S-register to be read fol-
lowed by a question mark and press
Enter .
Example:
ATS0?
The ISU 2x64 uses S-register strings to store strings of digits for
stored phone numbers, SPIDs, etc.