ADTRAN IMUX-56, User Manual

Page: 19 / 30

Chapter 3. Operation
61200262L1-1A IMUX-56/64 Module User Manual 3-3
equipment, it may be necessary to change this time so that it matches
TXADD01.
TXADD01 Timer
Write security: 3; Read security: 5
Specifies the length of time both endpoints wait for additional calls to be
connected at the end of negotiation before deciding that the BONDING call
has failed. The factory default setting is sufficient for most calls to connect,
although when dialing overseas it may be necessary to lengthen this timer
to allow for slower call routing.
TXDEQ Timer
Write security: 3; Read security: 5
Specifies the length of time both endpoints attempt to equalize the network
delay between the bearer channels before deciding the BONDING call has
failed.
TANULL Timer
Write security: 3; Read security: 5
Specifies the length of time the answering endpoint attempts to detect the
BONDING negotiation pattern from the originating endpoint before decid-
ing the BONDING call has failed. It may be necessary to shorten this timer
if the DTE equipment using the BONDING module also has timer con-
straints for completing non-BONDING parameter negotiation.
TCID Timer
Write security: 3; Read security: 5
Specifies the length of time both endpoints attempt to negotiate an agree-
able value for bearer channels and channel capacities before deciding the
BONDING call has failed.
Call Stagger
Write security: 3; Read security: 5
Specifies the amount of delay between placing calls for outgoing BOND-
ING sessions. Table 3-2 defines the call stagger values.
Table 3-2. Call Stagger Values
Display value Meaning
No Stagger
There is no delay between the call dialing of a BONDING session.
500 ms
Wait approximately ½ second between the call dialing of a BONDING session.
1 sec Wait approximately 1 second between the call dialing of a BONDING session.
2 sec
Wait approximately 2 seconds between the call dialing of a BONDING session.