Adtec Edje 4000, User Manual

Page: 38 / 51

Appendix
Terminal Commands
General Instructions
The edje-4000 AVC configuration connection can be made with the on-board serial port or a telnet connection. The
configuration parameters for the serial connection are 115K 8N1. The serial port is on the back of the enclosure and is labeled
below as Terminal.
edje4000 Back Panel:
The unit ships with initial IP address of 192.168.10.48 and a subnet mask of 255.255.255.0.
A telnet connection on the standard telnet port can be made with the unit.
The initial user name is 'ADTEC' and the password is 'NONE'. ◊
♦
•
Commands can be executed from the terminal or telnet interface.
•
Commands follow the structure of * cmd parameters.
There must be a space between the * and the 'cmd'.
If there are no parameters listed, the unit will output the current settings. ◊
♦
See the examples in each command group below. ♦
•
Network Commands
Command Use Example
* lan Set Lan Mode
* lan ANEG
lan arguments are:
ANEG - Default setting, auto negotiate (10/100 only, default for 10/100)
(0).
100BH - 100Base Half Dulplex, (10/100 only) (1). Required for the
Adtec edje4000 AVC Encoder
100BF - 100Base Full Dulplex (10/100 only) (2).
10BH - 10Base Half Duplex (default for 10 only) (3).
10BF - 10Base Full Duplex (4).
* ipa Set IP Address * ipa 224.0.1.251
* ipm Set Subnet Mask * ipm 255.255.240.0
* gip
Set one of 4 gateway
addresses
* gip 0 192.168.10.1
Sets the first gateway to 192.168.10.1.
This command takes 2 parameters; the first identifies 1 of 4 gateway IP
Addresses, and takes the range from 0 to 3.
* msi Set Multicast send address * msi 238.5.6.33
* msp Set Multicast send port * msp 4568
* mmo Set Multi mode to send
* mmo SEND
This command takes either a 'SEND' parameter or a 'OFF' parameter.
This must be set to SEND in order to multicast video packets.
33 Appendix