IPC9000 Serie
−
Instruction manual v1.1
26
© ads-tec Industrial IT GmbH • Heinrich-Hertz-Str. 1 • 72622 Nürtingen • Germany
7.4 CAN card
The optional CAN bus card from PEAK features two separate CAN buses connected together via a 9-
pin Sub-D connector. The two buses are galvanically isolated from each other and from the device’s
electrical system.
Standards: the card supports CAN FD and is backwards compatible with the CAN standard 2.0 A/B.
Transmission rate: max. 1 Mbit/s per bus.
Please note that the maximum bus length depends on the set transmission rate. Typical values with
correct termination:
Transmission rate Bus length
1 Mbit/s
40 m
500 kbit/s
110 m
250 kbit/s
240 m
125 kbit/s
500 m
50 kbit/s
1.3 km
25 kbit/s
2.5 km
15 kbit/s
5 km
Devices delivered ex factory with the Windows operating system and CAN card already include the
appropriate drivers pre-installed.
For other cases, and if special configuration or programming software is required for the fieldbus nodes,
see
Connector pin assignment and termination information is available in section 5.2.3.
