ADRF ADXD-LPR, User Manual

Page: 20 / 56

Advanced RF Technologies, Inc. 20
3.1.1.2 Ethernet Port
The Ethernet port can be used to communicate directly with the ADXD DAS using a RJ-45 crossover cable or
can also be used to connect the ADXD DAS to an external modem box.
Figure 3-4 Ethernet Port
3.1.1.3 Host/Remote Switch
The Host/Remote Switch allows the user to switch the default Repeater IP, Subnet Mask, and Gateway of
the repeater to an alternative setup. These settings can be adjusted by logging into the ADXD DAS in HOST mode
and configuring the settings under the Modem Box Setting section under the Install Page of NMS.
Once the settings are set, flipping the switch to the REMOTE position will reboot NMS module with the new
alternate settings. Please note that when the NMS is set to the REMOTE position, DHCP is disabled and the NMS
will not automatically assign an IP address to any device that connects directly to the NMS.
Figure 3-5 Host/Remote Switch

Host IP: 192.168.63.1 (Fixed IP, unable to modify this IP address)

Remote IP: 192.168.63.5 (Default IP, but can be modified in Host mode)
3.1.1.4 Power Connection

For AC type(AC 110V)
ADXD-H-NMS-AC has two push-lock connectors for battery backup and AC power connection on the
front panel.
You should verify voltage and should turn on the power after power connection necessarily
LAN1
LAN0
HOST
LAN0
REMOTE