Binaural Microphone/Earphone
BME-200
Instruction Manual / Warranty Card
Thank you for your purchase.
Please keep these instructions as the warranty card is attached.
Failure to comply with this mark could
result in injury or death.
Ignoring this mark and handling it
incorrectly may result in possible injury to
the user and the contents physically
damaged.
For safe use
Do not use while driving.
・
This is a sealed and insulated earphone which makes
characteristics of ambient sound difficult to hear. Do not use
it while driving a motorcycle or car. Also stay alert when
using while walking.
Do not listen for long periods of time at high volume
・
Permanent hearing damage may occur if listened at high
volume for long periods of time. Because of the sensitive
nature of this product please set the volume in a low position.
Handling Precautions
・
This is a precision made product, do not disassemble, drop or
subject it to strong impact.
・
Do not store in direct sunlight or in any area subject to high
temperatures or high humidity.
・
Never immerse in water. Protect it from excessive moisture.
Always remove before showering, bathing, or swimming.
・
If product gets dirty wipe it off with a dry cloth.
・
Never use cleaning agents such as household detergents, soap,
alcohol, etc. for cleaning your product.
Accessories
Wind Screen
2 pieces
Ear pads L, M, S
2 each (M is pre-installed)
Carrying Pouch
1 piece
Instruction manual and warranty card
1
Features
Binaural recording microphone & earphone
・
The microphone is set at the same time the earphone is
positioned in the ear.
・
You can record the sounds that you hear as you listen.
・
During playback you can distinguish between sounds from
the front and rear as well as left and right.
・
Setting up the microphone is not necessary so the users hands
are free during recording.
Main Characteristics
◎
Microphone
Back electret condenser
Directional Characteristics
Omnidirectional
Impedance
1.6k Ω
Sensitivity
―36.5dB(1kHz 0dB=1V/Pa)
Maximum Input Sound Level
105dB
S.P.L
Frequency Range
30
～
20,000Hz
Signal to Noise Ratio
60dB
以上
Power Supply
Plug in power (1.5
～
10V)
◎
Earphone
Sealed dynamic inner ear-earphone
Unit size
Φ
13.5mm
Impedance
19Ω
Sound Pressure Level
112dB/mW
Maximum Input
50mW
Frequency Range
100
～
10,000Hz
◎
Microphone/Earphone
Cord
2mm diameter (2 core sh 2 core
pair) x 2
Gold plated stereo mini plug x 2
Weight
Approx. 35g
Read Before Use
Size M ear pads are pre-attached. If it does not fit replace
with either the size L or S until you receive a desired fit.
・
Fit the ear pad to the opening of the
earphone.
・
Firmly
hold
the
earphone
microphone with the left (or right)
finger. Grab and hook a part of the
pad. While pressing with your left
(or right) index finger with your
other thumb and forefinger pull
towards you the ear pad until the
hole extends over the groove. Pinch
gently between your fingers to
assure it will not come off.
Connection
Earphone plug (green)
Connect headphone jack to
the audio equipment or video
camera.
Microphone Plug (red)
Connect microphone jack to
audio equipment or video camera.
This requires plug-in-power.
Please note that this jack cannot
be used unless it is plug in power.
Warning
Caution
Warning
Caution
