7
■
Place the Remote Controlled Admiral ATV-NAV into the pool and if needed rock the cleaner side to side to release any trapped air.
The cleaner will sink to the bottom of the pool.
■
Place a sufficient length of the blue power cord into the water that will enable the
Remote Controlled Admiral ATV-NAV to easily reach all areas of the pool.
(Do not place ALL of the blue power cord into the pool).
■
Turn on power supply at dedicated 220-240V, 50Hz AC electrical outlet and switch
power supply (transformer) to the on position, and the Remote Controlled Admiral
ATV-NAV will
begin its cleaning program.
■
The Remote Controlled Admiral ATV-NAV will automatically shut itself down
after three hours.
■
If a second cleaning is required or the Remote Controlled Admiral ATV-NAV is accidentally shut off, you should wait one minute before
switching the cleaner on again. The cleaner has an automatic lock out period to protect the electronic intelligent navigation devices.
IMPORTANT NOTE:
During normal operation, the Remote Controlled Admiral ATV-NAV may appear to shut off for a few seconds. This is a normal part of the pool
cleaning program. The cleaner has multiple ways of cleaning the pool walls. It may climb to the top of the pool wall, scrub, then make a turn
and drive back down the pool wall to the bottom of the pool. It may also climb to the top of the pool wall, shut down for a few seconds, remove
itself from the pool wall, turn its pump motor on again, pushing itself down to the bottom of the pool away from the wall.
The Remote Controlled Admiral ATV-NAV may also climb the pool wall, scrub to the waterline, turn the pump motor off, and float away from
the pool wall down to the bottom of the pool. All of these variations have been programmed into the cleaner and are designed to quickly and
efficiently clean your entire pool.
The Remote Controlled Admiral ATV-NAV has also been designed to clean all areas of your pool. It will climb the pool walls, and occasionally
break the pool water surface. In the process of climbing the pool walls it may stay on the pool water surface and continue to operate from
several seconds to a few minutes. This is a normal operation procedure and the cleaner will eventually make its way to the bottom of the pool to
continue its cleaning program. Generally, most of the dirt is concentrated on the floor of a pool the cleaner will spend the majority of cleaning
program on the pool floor.
REMOTE CONTROL OPERATION
To use the remote control feature, place the Admiral ATV-NAV Robotic Pool Cleaner into the swimming pool. Push the 3-hour switch on the
power supply to the on position. Wait 10 seconds. Press and release any switch on the remote control to activate the remote control feature.
DO NOT HOLD THE BUTTON DOWN, AS THE ADMIRAL ATV-NAV ROBOTIC POOL CLEANER WILL TRAVEL IN THE DESIRED DIRECTION UNTIL THE RED STOP
BUTTON IS PUSHED. There will be an audible beep from the remote control, indicating that the command has been sent to the Admiral ATV-NAV
Robotic Pool Cleaner. The Admiral ATV-NAV Robotic Pool Cleaner will stop moving, but the pump motor will continue to run and filter water.
If the Admiral ATV-NAV Robotic Pool Cleaner needs to travel to the right, press and release the right arrow button. When the Admiral ATV-NAV
Robotic Pool Cleaner has turned to the desired area, press and release the RED stop button. Press and release either the forward or back
button to make the Admiral ATV-NAV Robotic Pool Cleaner travel in that direction. By using these simple inputs you can easily guide the unit to
any area of your pool. To exit the remote control feature, press and release the button marked AUTO. The Remote Controlled Admiral ATV-NAV
Robotic Pool Cleaner will resume its cleaning program and automatically shut off when it reaches the end of its cleaning cycle.
Note: If, while in remote mode, the Admiral ATV-NAV Robotic Pool Cleaner begins floating on the water’s surface, press the the STOP button on
the remote until the Admiral ATV-NAV Robotic Pool Cleaner floats to the bottom of the pool.
