ADLINK Technology PXIe-3988, User Manual

Page: 37 / 81

Getting Started 25
PXIe-3988
4. Place a fresh identical battery (CR2032 or equivalent) in
the socket, ensuring that the positive pole (+) is facing
upwards. The battery is most easily seated by first being
inserted under the positive retaining clip, and then
pushed downward at the negative retaining clip. The bat-
tery should easily snap into position.
5. Reinstall the PXIe controller into the PXI chassis and
restore power.
2.2.5 Clearing CMOS
In the event of a system malfunction causing the PXIe controller to
halt or fail to boot, clear the CMOS and restore the controller BIOS
to its default settings. To clear the CMOS:
1. Shut down the controller operating system and turn off
the PXI Chassis.
2. Remove the PXIe controller from the chassis. Observe
all anti-static precautions.
3. Locate the CMOS clear switch (SW1) on the board (see
section 1.3.9: "Onboard Connections and Settings" on
page 15). Move the switch from the Normal position...
...to the Clear position.
Wait five seconds, then return the switch to the Normal
position.