ADLINK Technology NuPRO-710 Series, User Manual

Page: 59 / 67

BIOS Setup
•
51
Important!: This utility will only detect one set of parameters for an IDE
hard drive. Some IDE drives can use more than one set. This
is not a problem if the drive is new and there is nothing on it .
If the hard disk drive is already fully formatted when you install
it and different parameters than those detected here were
used, you will have to enter them manually.
If the parameters listed don’t match the ones used when the
drive was formatted, the drive won’t be readable. If the
auto-detected parameters displayed do not match the ones
that should be used for your drive, do not accept them. Press
the <N> key to reject the values and enter the correct ones
manually from the Standard CMOS Setup screen.
4.13 Save and Exit Setup
The next selection on the Utilities menu is “SAVE AND EXIT SETUP”. If you
select this and press the <Enter> key the values entered during the current
session will be recorded in the CMOS memory on the mainboard. The
system will check it every time you turn your system on and compare it to
what it finds as it checks the system. This record is required for the system
to operate.
Exit Without Saving
The last selection on the main screen is “EXIT WITHOUT SAVING”.
Selecting this option and pressing the <Enter> key lets you exit the Setup
Utility without recording any new values or changing old ones. If you want to
save a new configuration, do not use this option. If you use it, any new setting
information will be lost.
You can now use your system without further reference to this utility unless
you change the hardware configuration. Remember, if the system
configuration information stored in CMOS memory gets corrupted, you will
have to reenter it.