39
HPERC-KBL-M
Bits per second
9600
19200
38400
57600
115200
Selects serial port transmission speed. The speed
must be matched on the remote computer. Long or
noisy lines may require lower speeds.
Data Bits
7
8
Data Bits.
Parity
None
Even
Odd
Mark
Space
A parity bit can be sent with the data bits to detect
some transmission errors.
Even: parity bit is 0 if the num of 1’s in the data bits
is even.
Odd: parity bit is 0 if num of 1’s in the data bits is
odd.
Mark: parity bit is always 1.
Space: Parity bit is always 0.
Mark and Space Parity do not allow for error
detection.
Stop Bits
1
2
Stop bits indicate the end of a serial data packet. (A
start bit indicates the beginning).
The standard setting is 1 stop bit. Communication
with slow devices may require more than 1 stop bit.
Flow Control
None
Hardware RTS/CTS
Flow control can prevent data loss from buffer
overflow. When sending, if the receiving buffers are
full, a ‘stop’ signal can be sent to stop the data flow.
Once the buffers are empty, a ‘start’ signal can be
sent to re-start the flow. Hardware flow control uses
two wires to send start/stop signals.
VT-UTF8 Combo Key
support
Disabled
Enable
Enable VT-UTF8 Combination Key Support for
ANSI/VT100 terminals
Recorder Mode
Disabled
Enable
On this mode enabled only text will be sent. This is
to capture terminal data.
Resolution 100x31
Disabled
Enable
Enables or disables extended terminal resolution
Putty Keypad
VT100
LINUX
XTERMR6
SCO
ESCN
VT400
Select Function Key and Keypad on Putty.
Redirection After BIOS
Post
Always Enable
BootLoader
The Settings specify if BootLoader is selected then
legacy console redirection is disabled before
booting to legacy OS. Default value is Always
Enable which means Legacy console Redirectioin
is enabled for Legacy OS.
Feature
Options
Description
