ADLINK Technology cPCI-6765, User Manual

Page: 19 / 82

Getting Started 11
4. Continue inserting the card until the handles engage with
the chassis.
5. Pull inwards on the handles for final insertion. Ensure
that the red buttons on the handles fully latch into posi-
tion as unless this is done the card is not correctly
inserted. Fasten the retaining screws at each end of the
card (2 for single slot cards, 4 for double slot cards)
Figure 2-2: Latching the cPCI module handles securely.
6. To remove the module, undo the retaining screws, press
the red release buttons, and reverse steps 1 through 5
above.
2.3 Rear Transition Module Installation/Removal
The installation and removal procedures for a Rear Transition
Module (RTM) are the same as those for CompactPCI boards.
Because they are shorter than front boards, pay careful attention
when inserting or removing RTMs. Only models with an “R” at the
end of the model number support RTMs.
Note: We strongly recommended the use of RTMs with AB type
connectors to prevent the damage to the backplane during
RTM installation.