ADLINK Technology cExpress-KL, User Manual

Page: 34 / 98

28
Pinouts and Signal Descriptions
Signal Pin Description I/O PU/PD Comment
P
PEG_TX15- D101
D102
PEG_LANE_RV# D54
PCI Express Graphics lane reversal input
strap.
Pull low on the Carrier board to reverse
lane order.
I 1.05V Not supported
3.4.6. Module Type Definition
Signal Pin Description I/O Comment
TYPE0#
TYPE1#
TYPE2# C54
C57
D57 The TYPE pins indicate to the Carrier Board the Pin-out Type that is
implemented on the module. The pins are tied on the module to
either ground (GND) or are no-connects (NC). For Pinout Type 1,
these pins are don’t care (X).
TYPE2# TYPE1# TYPE0#
X
X X Pinout Type 1
NC NC NC Pinout Type 2
NC NC GND Pinout Type 3 (no IDE)
NC GND NC Pinout Type 4 (no PCI)
NC GND GND Pinout Type 5 (no IDE, no PCI)
GND NC NC Pinout Type 6 (no IDE, no PCI)
The Carrier Board should implement combinatorial logic that
monitors the module TYPE pins and keeps power off (e.g
deactivates the ATX_ON signal for an ATX power supply) if an
incompatible module pin-out type is detected. The Carrier Board
logic may also implement a fault indicator such as an LED.
Type 6
3.4.7. Power and Ground
Signal Pin Description I/O PU/PD Comment
VCC_12V C104-C109
D104-D109
Primary power input: +12V nominal (5 ~ 20V wide
input).
All available VCC_12V pins on the connector(s)
shall be used. P 5-20 V
GND
C1, C11, C21, C31,
C41, C51, C60, C70,
C76, C80, C84, C87,
C90, C93, C96, C100,
C103, C110, D1, D11,
D21, D31, D41, D51,
D60, D67, D70, D76,
D80, D84, D87, D90,
D93, D96, D100,
D103, D110 Ground - DC power and signal and AC signal return
path.
All available GND connector pins shall be used and
tied to carrier board GND plane.
P