Note : controller with built-in clamp diode
It is necessary to set I/O external/internal power supply select at
EXT, when controller with built-in clamp doide has been used. If I/
O external/internal power supply select is not correct, then motors
will run at controller power ON/OFF.
4.Signal output circuit
4-1 Signal output circuit
External power supply DC voltage should less than 26.4V and
current should less than 10mA.
Select suitable current limit resistor based on DC power supply
voltage.
■
30
Photocoupler
EXG
SPEED
OUT
EXT.
Compatible
with TLP521
INPUT
COM
INPUT
EXG
INT.
D305 Drives
+24V
Transistor
Clamp
diode
Controller
560
Ω
Summary of Contents for AM-120H
Page 11: ...4 2 Drive dimensions Unit mm 9 ...
Page 12: ...4 3 F306 dimensions Unit mm 10 ...