Page 4
2. Installation
2.1
Transport instructions
The Studio Auto Clam 38 comes to you
either shrink-wrapped or in a
box. If you have to transport the machine at any time it is
recommended that you use a similar box and packing method. Please
let the machine cool down and lower the handle to the locked position.
2.2
Installing the machine
2.2.1
Remove all
packaging from the heat press.
2.2.2
Check to ensure
that no damage has been caused to the
machine during transit.
2.2.3
Place the machine
on a sturdy horizontal surface that is within
easy reach of the operator that will allow space for the handle
to move up to the loading position. Ensure that no items
vulnerable to heat radiation are too close to the machine.
2.2.4
Remove the transit screw
that secures the handle in the down
position. The screw is located in the centre of the plate, above
the magnet.
2.3
Electrical requirements
The Studio Auto Clam 38 should
be connected to the mains supply,
(nominally 230VAC for the European Market) by the mains cable
provided and a suitable plug.
The press is designed
for 230VAC 50/60 hertz and require exclusive
use of a power outlet rated for at least 15 amps.
Ensure that
the supply rating on the machine specification plate
corresponds with your local supply and that the correct plug is fitted.
MAINS LEAD
The wires
in this mains lead are coloured in accordance with the
following code:
Green and Yellow
:
EARTH
Blue
:
NEUTRAL
Brown:
LIVE
