Page 2
1.2
Safety tips
♦
Our customer service
department
has its own service
engineers and, if required, maintenance is available.
♦
The Studio Auto Clam 38
meets the European Legislation
standard. Under normal conditions accidents are rare.
However listed below are some practical points to ensure your
safety.
•
This press will automatically open when the transfer
cycle is complete.
Make sure there is sufficient space
around the machine for the heat plate to rise from the
table, without interference.
Only persons fully trained
should operate this machine.
•
Always switch off
the current (and pull plug out of the
socket) when undertaking maintenance work or when
cleaning the machine.
•
Ensure that there is
sufficient space around the machine.
Cables and connections must not get jammed. Although
the heat radiation of the press is low, there should be
enough space for cooling down.
•
Avoid contact
with the heat plate.
♦
DO NOT REMOVE THE INSTRUMENT COVER
UNLESS QUALIFIED TO DO SO
- touching internal parts
is dangerous and may cause shock hazard. All electrical
connections inside covers are live. Never operate Press with
any covers and/or guards removed.
♦
PROTECT THE MAINS CABLE
- damage to the mains
cable may cause fire or shock hazard. When unplugging, hold
by the plug only and remove carefully. Take care that the
mains cable does not come into contact with the heat plate (or
moving parts of the mechanism) during operation of the
machine.
♦
OPERATING AMBIENT TEMPERATURE RANGE
-
the
operating ambient temperature range is 0
o
C - 35
o
C,
(32
o
F -
104
o
F)
and humidity of 20 - 80%.
♦
MACHINE FUSE(S)
–
15 Amps.
♦
WARNING - THIS APPARATUS MUST BE EARTHED
(GROUNDED)
♦
CAUTION
This machine gets hot whilst operating. Take care not to touch
any surfaces that are labelled “Caution this plate is HOT”.
